Contact

The comfort that you feel.

ecoGEO+ geothermal heat pumps for custom and high-performance homes. Heating, cooling, hot water and your pool from one quiet unit.

Schedule a Design ConsultationFind the right unitDatasheets and presentations

Everything in the house, from one unit.

Choose a home and tap a point on the plan to see what the unit does there.

Isometric drawing of a modern house with a garage and pool, with hairline green pipes running from a utility room to the radiant floor, a bathroom and the pool

Which unit fits your home?

Two questions. Your installer confirms the size for your loads.

How will heat reach your rooms?
Where should the hot water tank be?

ecoGEO+ Compact

    See the datasheet

    Warmth that comes from the floor.

    Forced air pushes heat through ducts and leaves it near the ceiling. Water warms the floor, and the heat rises evenly through the room.

    • Near the ceiling85
    • At your head70
    • At your feet65

    Warm air gathers at the ceiling and cooler air sinks to the floor. Your feet are the coldest part of the room.

    A mother and her daughter reading on a sunlit warm wood floor in a living room, with snow outside the windows and no radiator or vent in sight

    Warm floors, no drafts.

    Heat travels through water in the floor, so there are no vents or radiators in the room and nothing blowing on you.

    Pairs with your solar panels.

    When the panels produce more than the house uses, the unit raises its setpoints and stores the surplus as heat in the water tank, the floor and the pool. No battery needed.

    • Hot water
    • Heating
    • Cooling
    • Pool

    Normal conditions. The unit works to the standard setpoints.

    These temperatures are the water the unit sends through the pipes to heat or cool: hot water to the tank, warm water to the floor and the pool, chilled water to the fan coils. Example setpoints, set by your installer.

    A timber-and-stone home at dusk in a snowy landscape, with a clear wet driveway and a steaming pool

    Cold winters. Clear driveways.

    Ice melting runs from the same unit as the heating, the hot water and the pool. The ground stays at a steady temperature all winter.

    Where it fits.

    1. Dark timber-clad Passive House with a stone base and a large corner window

      Passive House and net zero

      Very small loads, solar PV and a system that manages the surplus.

    2. A stone house with solar panels on the roof in a mountain village

      Homes with solar

      A compact unit with HTR, hybridized with photovoltaic panels.

    3. A white two-storey villa behind a swimming pool

      Homes with a pool

      Pool heating and several heat sources managed by one control.

    4. Terraced homes in a residential development

      Developments

      A compact heat pump in every home, with heating, cooling and hot water.

    Replacing an old boiler?

    The unit goes where the boiler was. Pumps, vessels and controls come built in, so there is less to install.

    The same room renovated, with a clean white wall, a tidy ecoGEO+ unit and a grey storage tankAn old boiler room with a rusty oil boiler, a stained oil tank, an old water heater and worn pipesBeforeAfter

    ecoAIR air-source units also suit retrofits. Ask about retrofit

    An installer checking the display of an ecoGEO+ WWA unit, with its air ducts and six copper pipes connected

    From the first call to the first winter.

    1. Design consultation

      Tell us about the home, the loads and the rooms. Ecoforest’s technical office reviews the project at no cost.

    2. System design

      You get the unit, the hydronic schematic and the heat source sized for your home: ground loop, open loop or dry cooler.

    3. Certified installation

      A trained installer fits the unit. It arrives with its pumps, vessels and controls built in.

    4. Commissioning and support

      Ecoforest supports the start-up, and the unit can be monitored remotely through the app.

    Questions from homeowners.

    Will I hear it?

    Very little. The compressor is the latest generation and it changes speed instead of switching on and off, so there is no start and stop and it makes less sound. The insulation of our units is also designed to make less noise than a normal refrigerator. Sound data for each model is in the datasheets.

    Does it heat and cool?

    Yes. The Compact and Basic cool through fan coils or radiant surfaces, and the WWA also cools through air. Some models cool passively with the ground loop, without running the compressor.

    Can it heat my pool?

    Yes. Pool heating or ice melting is managed by the same unit, with its own setpoint.

    How hot is the hot water?

    149 °F on demand, and up to 167 °F when the HTR heat recovery is used.

    How much space does it need?

    A Compact unit takes about 10 square feet and stands 6 feet tall. Your installer confirms the layout.

    Are there incentives?

    The federal residential tax credit ended after 2025. State and utility programs may still apply. Your installer can check what is available in your area.

    Who installs it?

    Installers trained and approved by Ecoforest. If you want an installer, fill in the form below.

    Start with a design consultation.

    Send us the plans or the loads. We will come back with the unit, the schematic and the heat source.

    Schedule a Design ConsultationDatasheets and presentations

    If you want an installer, fill in the form.